Cart 0

Graphene field effect transistor biosensors

Marko Spasenovic graphene biosensor graphene fet graphene field effect transistor graphene sensor

Graphene and other 2D materials are excellent candidates for use in biosensing, due to a multitude of favorable properties. The 2D nature of the materials in itself provides intrinsic advantages, because the entire material volume acts as a sensing surface. Furthermore, graphene provides excellent mechanical strength, biocompatibility, thermal and electrical conductivity, compactness, and potentially low cost.

Two types of biosensors that utilize graphene are emerging as the most promising technologies: surface plasmon resonance (SPR) and graphene field effect transistors (GFET). Although SPR methods have potentially faster readout, the technique is still experimental. GFETs rely on well-established technology of charge carrier density changes in the presence of an analyte. In a broad and intense research spur of recent, GFETs have been used as immunosensors, enzyme, DNA, protein, glucose and bacteria sensors, among other applications.

Image: Scheme of a biosensor (reproduced from Materials Today 14, 308 (2011), creative commons).

GFET is a modification of the classic silicon field-effect transistor, ubiquitous in modern electronics. In traditional transistors, silicon acts as a thin conducting channel, the conductivity of which can be tuned with applied voltage. GFETs perform in a similar manner, except that the silicon is replaced with graphene, which yields a much thinner and hence more sensitive channel region. In sensing mode, channel conductivity is perturbed in the presence of an analyte. Due to the broad electrochemical potential and ability to be functionalized, GFETs present an attractive device for biomolecules to attach to, and because of graphene's ultimate thinness and extreme surface-to-volume ratio, electrical properties are sensitive to even the smallest concentration of attached molecules. Using GFET, biosensors with a detection limit of 10 pg/mL were produced for opioid molecules.

GFETs for biosensing can be reproducibly mass-made with established fabrication technologies. Si/SiO2 wafers that are standard in electronics are used as the substrate. Graphene can be grown with chemical vapor deposition (CVD) and transferred with dry or wet methods. Electrical contacts are deposited by thermal evaporation of metals in a lithographically pre-defined configuration.

The potential of graphene in healthcare is exemplified by the project 2D-Health, funded by the UK agency EPSRC and worth £5.2m over the next five years. Graphene and other 2D materials are set to be used in innovative solutions for specific unmet clinical needs in wound care and management (relevant to diabetes), tissue rehabilitation by electrical stimulation (relevant to dementia), cell therapeutics (relevant to cardiovascular disease), and immunotherapeutics (relevant to cancer). Please fill the quick survey below!


Older Post


Leave a comment

Please note, comments must be approved before they are published

Subscribe to our newsletter